+  Central Florida Fieros Forum
|-+  Recent Posts
Pages:  1 ... 8 9 [10]
 on: October 17, 2018, 07:15:59 PM 
Started by Lamborghini - Last post by 2002z28ssconv
There are a few that are building customs, chop tops and such. Nobody building an actual kit right now that I'm aware of.

 on: October 17, 2018, 06:56:18 PM 
Started by draco24433 - Last post by 2002z28ssconv
There are usually a couple of guys there that will pull parts for you if you pay them.

 on: October 15, 2018, 07:15:32 PM 
Started by draco24433 - Last post by draco24433
Awesome. Thanks. I will try it during the weekend.


 on: October 15, 2018, 09:35:36 AM 
Started by Lamborghini - Last post by Lamborghini
Anyone building a Kit Car using a Fiero as a donor?

 on: October 14, 2018, 07:52:05 PM 
Started by draco24433 - Last post by f85gtron
Hi Alex,
Check both the intake temp sensor and engine coolant sensor when engine is cold. Both sensors should ohm out similarly readings. You could also check temps using Aldl readings too. Thatíd be better because then you can see what the ecm sees. ohm table.
If the readings donít match at cold, one of them has failed.
The reasoning is if the ecm thinks the motor is cold, it will keep idle commanded high and will also not allow closed loop operations (kind of like the choke is on).
The other culprits are vacuum leaks and the biggest is the egr tube. But looks like youíve addressed that already.
Hope this helps!

 on: October 14, 2018, 10:38:36 AM 
Started by draco24433 - Last post by draco24433

Do they pull it for you or do you have to do it yourself?

 on: October 14, 2018, 10:31:32 AM 
Started by draco24433 - Last post by draco24433

For a while now, I have been dealing with a high idle condition that will not go away. I have an 87 GT that I bought from a guys who had it sitting for a couple of years. Initially, the idle was high and hunting but I have eliminated the hunting condition. Here are the things I have done and checked to make sure all is ok.

1. Replaced Fuel sender and pump (both were not working)
2. Replaced spark plugs. Cables looked in good condition so no change there
3. Replaced the IAC with the old one since the new one did not work.
4. Replaced vacuum lines. Old ones were brittle and broken. No vacuum leaks now. checked by spraying carb cleaner.
5. Replaced fuel injectors since old ones were not good
6. Replaced EGR and tube with one from Fiero Store
7. Fuel pump holding holding correct pressure

I have tried numerous times to set the timing per the manual instructions (at least 7 times). I now have the idle from 3K rpm down to 1800 rpm. When ALDL is grounded, the timing is at 10 degrees. Once I finish setting the timing and I remove the ground, the timing goes from 10 degrees to a higher one past the 12 degrees.

At this point I need help from one of you since I cannot find the problem and I do not know what else to do. I would gratefully appreciated.


 on: October 13, 2018, 10:44:50 PM 
Started by draco24433 - Last post by 2002z28ssconv
There's an 88 Formula "ITA race car" with a 5 speed at the Orlando LKQ.

The cradle was there last weekend.

 on: October 13, 2018, 10:43:43 PM 
Started by f85gtron - Last post by 2002z28ssconv
Yep - Welcome.
We meet on the 1st Thursday of every month in Casselberry. Most arrive between 6:30 - 7:00.
Publix parking lot on 17-92.
Then we go inside Anthony's Pizza and usually wrap up around 9:00.

We aren't a very "structured" group. Pretty laid back.

 on: October 13, 2018, 06:54:24 PM 
Started by f85gtron - Last post by draco24433

Welcome to the club. We look forward to seeing you next meeting.


Pages:  1 ... 8 9 [10]
Go to CFF Club & Vendor links.